hehe got bored new toy

[savs2k]

http://whatacountry.com/bulgarian-ak-47-milled-parts-kit.aspx

comes out to $200 but it'll give me something to do. I'm still an ak noob though never done a build on a us barrel before. Same thing though right? where can i find a a cut receiver for a reweld for this kit?

[247Nino]

These go in milled receivers. You can however put it in a flat with front and rear trunnions. It will take some fitting.

[savs2k]

reweld it is.

[tujungatoes]

You've got a lot of work ahead of you with that. If you haven't already, read grossekatz's galil re-weld thread. There's also a guy on theakforum that did a polish one.

[nicoroshi]

Toes, do you know where to get the Bulgarian cut receivers?

[tujungatoes]

I see them pop up on theakforum and akfiles from time to time. They're few and far between as I understand it. Might be able to substitute some of those polish ones if apex still has 'em

[savs2k]

anyone know where I can find blueprints for the milled receiver for this? If it's that hard to find i'll just make a few of them and buy more kits if possible. It was more of an impulse buy then anything. I felt like i needed a project to keep my mind off things apperently i made a good choice

[nicoroshi]

That kit could easily be made to work with a pressed flat.
Buy the front, and rear trunnions, and get that barrel head spaced, and populated, and you're GTG.
Head space and populate of a virgin barrel will certainly keep you busy for a while if you've never done it before.