Savage 110 BA Problem

[In My Cold Dead Hands]

150 yards and it was zeroed still but windage was still adjusted all the way out counter clockwise. I should say there was absolutely no wind that day ay Sac Valley Shooting Center. It zeroed fine with laser with plenty of adjustment availability but the shots were off at 25 yards with no adjustment availabilty left meaning the dial was turned all the way out counter clockwise...

[Whiterabbit]

did you shoot anything past 25 yards? once zeroed ther,e was it at zero at 50 and 100? how far did you go then quit since you (as you say) have no adjustability?

[Whiterabbit]

so.... it shoots so far to the left at 25 yards you cannot zero windage at any distance, except 50 yards, where you can boresight your groups in with no issues with plenty of adjustment in all directions?

Or did you say you can boresight without issue, which may or may not have anything to do with how the rifle shoots whatsoever, confirming with no rounds down range or any indication where the rifle shoots at all, and then, after that, try to shoot 25 yards and have issues?

My first thought is bore sighting means nothing for you (for this rifle). Next I would be looking for copper deposition on the brake, muzzle face, down the bore, checking the barrel contact in the stock at the foreend tip, looking at the scope rail mount, and after that I would probably be very puzzled.

[In My Cold Dead Hands]

zeroed my new out of the box .300 Win Mag with 3 different scopes achieving the same results:

The firearm will zero with a laser bore sight at 50 yards with plenty of windage adjustment to the left and right with the intended scope of use (Nightforce NXS zerostop 8-32x56 purchased new as well) and it is consistantly shooting 6-7 inches left at 25 YARDS!!!! Other than sending it to Savage (3-6 week turnaround time) any suggestions? The windage dial on all scopes tested (Burris 3-9x40, Trijicon ACOG, Nightforce mentioned above) has to be maxed counter clockwise just to zero at 25 yards. I have no room to adjust longer shots if needed. Factory Ammo (Federal 155 gr) 40 rounds have been shot through it. How can ths gun bore sight evenly with a laser but shoot so far to the left? Any help is much appreciated. I'm thinking there is a barrel issue or muzzle brake issue. Thoughts, comments?

-Extremely frustrated