A tutorial for AK build parties.

[69Mach1]

Bump for the build party.

Print this out.

See you all there.

[nicoroshi]

You do extremely nice work 69Mach1.
Both in your tutorials, and your builds.

[69Mach1]

You do extremely nice work 69Mach1.
Both in your tutorials, and your builds.

Thank you sir.

[AIMSMALL]

Thank you. How about a pic of the almost finished products? I'm so lazy.


Oh, and here's were you can get it on PDF.
http://www.calguns.net/calgunforum/s...42#post4306842

So how did you refinish the stocks? Is the reciever just painted?

[69Mach1]

AIMSMALL, they're both just parkarized. I haven't had the time to paint any of them yet. I've got 12 cans of alumahyde II just sitting here....lol

[Z ME FLY]

AIMSMALL, they're both just parkarized. I haven't had the time to paint any of them yet. I've got 12 cans of alumahyde II just sitting here....lol

oh really? then that means we gonna paint my krink when i end up down there again LOL

it needs it BAD...

[69Mach1]

oh really? then that means we gonna paint my krink when i end up down there again LOL

it needs it BAD...

Absolutely. Was it park'd at the last party?

[Z ME FLY]

Absolutely. Was it park'd at the last party?

Yeah but I reparked it at the norcal bp and it ended up gray. Then the fake can finish came off so I just went ghetto and spray painted it for now.

[NorCalDustin]

In addition to these tips, a small and large hand file, some sand paper, and a punch set are needed.

What kind of sand paper?

[69Mach1]

What kind of sand paper?

250 grit is best, nothing harsh.

[Contract_Pilot]

I did a video on using the AK-builder bending Jig... was my First You Tube Video...

http://www.youtube.com/watch?v=wqdnQ1Yei_4

[YT]wqdnQ1Yei_4[/YT]

[Tisdel]

Folder Angle

Nice work Mach. I like the way it shows off the differences in folder material and angle. The Romy gives you a chance at good sight picture without having to work so hard at bending. The others are a little better on recoil by being a straight line.

This is a little off the subject.

But is there anyway to get an AK-47 buttstock that has as more of a downward angle to it than the standard buttstock (like the one folder shown)?

I'm trying to find either a fixed buttstock, or even better an adjustable buttstock, that angles more toward the ground.

Any ideas?

[MikeWilliamson]

It's not hard to carve your own AK stock from either wood or laminate. I've made several. Measure from an existing one, mark with a grease pencil, cut with a saw, pound to fit, paint to match.

[69Mach1]

This is a little off the subject.

But is there anyway to get an AK-47 buttstock that has as more of a downward angle to it than the standard buttstock (like the one folder shown)?

I'm trying to find either a fixed buttstock, or even better an adjustable buttstock, that angles more toward the ground.

Any ideas?

Go with Chinese. You may have to shim it a little, or you may get lucky.

[nicoroshi]

So Mach..............
You gonna add to this tutorial for milled re-weld builds also?
(crosses fingers , and says a little AK builder prayer).