No, thats not how it works.
Dented cases are not an issue unless they are creased. I have brass that has been stepped on, slammed against walls and obstacles, thrown in the gravel, case mouth out of round, lip a little bent, and it forms right back, dents or no dents. Just clean, load, and go.
There is no good reason to use a hand loader if you have another press, and certainly not a good reason to use one as a case gauge. I have a hand loader, and the only thing it is good for is to keep around in case I go on a long road trip and might have to load a few on the fly in a hotel room.
OP buy a case gauge, you use it after you load. It is less important if you are loading on a single stage and are batch processing. On a progressive where you are going fast a case gauge prevents a round from not getting resized quite right and causing an issue.
Dented cases are not an issue unless they are creased. I have brass that has been stepped on, slammed against walls and obstacles, thrown in the gravel, case mouth out of round, lip a little bent, and it forms right back, dents or no dents. Just clean, load, and go.
There is no good reason to use a hand loader if you have another press, and certainly not a good reason to use one as a case gauge. I have a hand loader, and the only thing it is good for is to keep around in case I go on a long road trip and might have to load a few on the fly in a hotel room.
OP buy a case gauge, you use it after you load. It is less important if you are loading on a single stage and are batch processing. On a progressive where you are going fast a case gauge prevents a round from not getting resized quite right and causing an issue.

Comment