Tweet
So I'm cleaning down my ar just now and I'm putting back all my pieces and notice my flash hider looks a little off from where it normally is positioned. I barely touch it and the thing is really loose. How tight are these suppose to be on?? Has anyone ever had this happen?
-
-
tight enough for the crush washer to be flat. Just dont make it loose haha -
It should be tightened with a wrench until it's lined up with all of the exhaust cuts facing up. There should be a crush/peel washer between the flash hider and the barrel that provides the proper torque and alignment. They make a special muzzle wrench, but in reality, you can do it with any wrench that fits the nut.Comment
-
3/4 inch open end wrench.Using gun control to stop crime is like trying to put out a fire with gasoline!
You don't have to get permission to exercise a RIGHT. If you have to get permission or can be told no by the government it is no longer a right. IT IS A PRIVILEGE!
AR-15 ASSEMBLY CHECK LIST FOR BUILDERSComment
There are currently 3814 users online. 180 members and 3634 guests.
Most users ever online was 65,177 at 8:20 PM on 09-21-2024.
Comment