Unconfigured Ad Widget

Collapse

Trigger issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • #16
    6mmintl
    Veteran Member
    • Apr 2008
    • 4822

    Are your recesses/pockets the correct depth? is the trigger bottoming out against the back/front recess/pocket?

    Comment

    • #17
      vlady
      Senior Member
      • Apr 2013
      • 719

      Originally posted by 6mmintl
      Are your recesses/pockets the correct depth? is the trigger bottoming out against the back/front recess/pocket?
      It is not bottoming out. After I shaved the disconnector tooth, trigger works perfectly. Still catches the hammer when you hold the trigger after pulling the trigger and holding it whole pushing back the hammer, then smooth reset when letting the trigger back
      sigpic

      Comment

      • #18
        cabinetguy
        Release the Cabinets!
        CGN Contributor - Lifetime
        • Sep 2010
        • 12659

        I will guess your trigger pin holes are off. I had a similar issue and the holes were off by a few thousandths

        Comment

        • #19
          vlady
          Senior Member
          • Apr 2013
          • 719

          Originally posted by cabinetguy
          I will guess your trigger pin holes are off. I had a similar issue and the holes were off by a few thousandths
          I think you're on the spot with that assessment. I'm just happy that I have a functional trigger group and it didn't take long to do so if I ever needed to change triggers, a little filing and sanding is all it will take.
          sigpic

          Comment

          Working...
          UA-8071174-1