Unconfigured Ad Widget

Collapse

Replacing Front Sight Base

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • akjunkie
    CGN/CGSSA Contributor - Lifetime
    CGN Contributor - Lifetime
    • Jan 2005
    • 3497

    Replacing Front Sight Base

    Would like to install a traditional Front Sight Base on my barrel.
    Not interested in the "Clamp On" styles, etc.

    I've heard some people say the "Tapered Pin" holes are individually drilled for each FSB. Meaning my replacement FSB might not line up.

    I've also heard others say the holes (on top of the barrel) are pre drilled on the assembly line and any "mil spec" FSB should line up perfectly.

    Comments?
  • #2
    wash
    Calguns Addict
    • Aug 2007
    • 9011

    The hole spacing is probably close enough if they used an in spec drill jig. Tapered pins also give you a little wiggle room that disappears when you pound them in.

    If it was a problem, you would see people selling tapered reamers for AR pins. I've never seen them so that means either lots of clamp on front sight gas blocks (I've got one) or it's not a problem.
    sigpic
    Originally posted by oaklander
    Dear Kevin,

    You suck!!! Your are wrong!!! Stop it!!!
    Proud CGF and CGN donor. SAF life member. Former CRPA member. Gpal beta tester (it didn't work). NRA member.

    Comment

    • #3
      kcstott
      I need a LIFE!!
      • Nov 2011
      • 11796

      Well tapered reamer wouldn't help unless the misalignment is slight. Ream to deal and your pin won't grab.
      That said I've seen them both ways good and bad.
      The bigger issue is getting the sight correctly aligned. There's not much windage in a rear sight

      Comment

      • #4
        Dreaded Claymore
        Veteran Member
        • May 2010
        • 3231

        Originally posted by kcstott
        Well tapered reamer wouldn't help unless the misalignment is slight. Ream to deal and your pin won't grab.
        That said I've seen them both ways good and bad.
        The bigger issue is getting the sight correctly aligned. There's not much windage in a rear sight
        Ach...I hadn't thought of that.

        Comment

        Working...
        UA-8071174-1