Ak pistol ?

[croc4]

Hey Guys,

I have a question concerning the building of an AK pistol, I understand that it must be built as a single shot first before converting it to semi auto. This is done by blocking the magazine to not accept any rounds correct?, or is there another method of getting a 'single shot' AK pistol?

Thanks,

Croc4

[Fern]

you can tack weld the follower to the body.

[wash]

The magazine must also be fixed to be single shot and also to avoid "assault weapon" status.

Another method would be to not drill the gas port making it a ~straight pull bolt action. I think that might count as a single shot, I'm not 100% sure.

[Ub3rD0rk]

Do not drill the gas port and do not trim the lower rails. That is what I do personally, with the lower rails untrimmed you can not insert a mag into the receiver. If the gas system is inoperable, it can't be confused as a semi auto at all. Make sure your barrel is at least 6" but shorter than 16". Also ensue that the over-all length is more that 10.5". Take a bunch of photos, then start your conversion to whatever you want.

The photos are for JUST IN CASE situations.