Razor 10/22 80%

[nat]

I built the 10/22 mag version this weekend.

[12voltguy]

Wow; I approve of their willingness to take it back but subtle $h1t talking is really inappropriate.

I guess all I can say is that if finish is important to anyone reading this, buy the unanodized version so that you can remove all of the bad blends and burrs, because apparently Selectfire is not going to do it for you nor do they think they should.

I just bought 3
1 ano 2 raw, 2 friends wanted them
the ano is still crappy as stated

TM is still out or I would have got there jig & 80

this is 1st I have seen pics of barrel hole.thx posterI have a mill, clamps, blocks vice undersize bit & reamer
just wanted a pic of how it was held.

Now I just need some time

[CEDaytonaRydr]

I didn't know it was thit much work to do these. I though you just had to drill/tap the holes for the barrel wedge, and drill the holes for the trigger group and bolt stop.

I still kinda want one, though...

[CptDan]

I have finished my Rcvr and now waiting for some parts to show up. I saw something last night about a different kind of barrel block. A lot of 10/22 suffer from barrel pull down due to the nature of the wedge and the fact that there is little too much clearance between the barrel and rcvr. This guy makes a block the is essentially flat and it pushed against the barrel with out wedging it down. I want to try making a wedge to fit the barrel cut and milling out a block that will contact the wedge which will have a flat back. Check this : http://www.gunsmithertools.com/gunsm...022-elevation/

[Ytisfedup]

Nice job dude!. I may hit you up for that barrel reamer when and if mine ever shows up from TM.

[Lostsheep]

Nice job dude!. I may hit you up for that barrel reamer when and if mine ever shows up from TM.

No problem, you know what I charge for rentals---beer!