Per the aforementioned Bunker Arms text:
"The rim itself is also 0.025" vs 0.040" (0.035 act.) in depth. If you fit the 9mm extractor in the same manner as the 45, not only would your claw get reduced to about 0.020" to ensure clearance on variety of cases, it also has to move radially towards the center of the bore to make up for the difference of 0.050" per side case diameter... meaning bending at a greater angle AND removing more material from the fitting pad for clearance in the extractor tunnel to achieve a proper amount of deflection since the extractor tunnel is in the same location on 45 slide and a 9mm slide. As a result of this, many smiths, including myself, have decided that engaging the case with the claw in the extractor groove would allow for maximum contact with the claw on the rim, since you can maximize the entire 0.025" depth, while maintaining less of a bend in the extractor to make contact which is more difficult to tension properly and exacerbates the 90 degree claw angle itself. The 9mm case pressure is around 15,000 psi greater than 45 so the additional expansion in the chamber could use the additional claw contact.
HOWEVER, it is still very important that neither 45 or 9mm claws contact the case bevel in the extractor groove, as again, this will prevent the case from seating square with the breechface. This can cause issues with both feeding and accuracy. I also take this one step further and add a slight bend down on the extract because just as the case is further in radially, it drops further axially as well when the barrel drops out of battery."
"The rim itself is also 0.025" vs 0.040" (0.035 act.) in depth. If you fit the 9mm extractor in the same manner as the 45, not only would your claw get reduced to about 0.020" to ensure clearance on variety of cases, it also has to move radially towards the center of the bore to make up for the difference of 0.050" per side case diameter... meaning bending at a greater angle AND removing more material from the fitting pad for clearance in the extractor tunnel to achieve a proper amount of deflection since the extractor tunnel is in the same location on 45 slide and a 9mm slide. As a result of this, many smiths, including myself, have decided that engaging the case with the claw in the extractor groove would allow for maximum contact with the claw on the rim, since you can maximize the entire 0.025" depth, while maintaining less of a bend in the extractor to make contact which is more difficult to tension properly and exacerbates the 90 degree claw angle itself. The 9mm case pressure is around 15,000 psi greater than 45 so the additional expansion in the chamber could use the additional claw contact.
HOWEVER, it is still very important that neither 45 or 9mm claws contact the case bevel in the extractor groove, as again, this will prevent the case from seating square with the breechface. This can cause issues with both feeding and accuracy. I also take this one step further and add a slight bend down on the extract because just as the case is further in radially, it drops further axially as well when the barrel drops out of battery."

Comment