Ar15 jigs capabilities.

[80% Arms]

The 80% Arms Universal AR-15 Easy Jig is fully compatible with all the lowers listed on the list. An update to the chart is in order.

[Jeepers]

thanks for the chart

[Jscanlan]

2nd try
Good info. If it is a text file change it to a PDF document and then post that.
You can create a PDF by going to your print and have it create the PDF there.

[80% Arms]

This should also help to make a new updated graph

We combined the data from the chart you provided with the data from the chart from 80 Percents. We updated our data on the chart. If any of the jig vendors have new info they want to provide to us, we'll further update / expand the chart.

Chart data compiled from:

http://www.80percents.com/80_lower_comparison_chart.html

http://www.tr-enabling.com/v/vspfiles/assets/images/compatibility%20chart.jpg

[FIREBALL_BRIAN]

if you can mill a lower. you can make your own jig. If you buy a jig, you can mill it to accept all lowers. 5 min of your time is all it takes.

[Bullets&Whitewalls]

I had an ares armor LR308 jig and the 80% arms ez jig, Since I loved the ez jig so much After a little measuring I found that using the upper plates from the ez jig I was able to mod the Ares jig to accept them to allow the router to be used on the Lr308 lower with great results. What I did is using the pins in the ares jig I mocked it up with a lower and clamped it into place and checked center. Then I transfer punched through the spacer to the plate without pins and drilled and tapped it. Then I was able to mount the ez spacer and plates to the lr jig. I had to mod the the top deck as well to clear the buffer tube mount when it is in place. Using the hand held router it is fine. And depending on what lower you install it sits flush. Tactical machine lowers will fit as well. The lr308 fcg pocket is the same as AR15 and measured off the rear take down you can verify this. AR10 and SR25 are not the same from what I can tell so these wont work with those. If there are 80% avail at least.

[TATER313]

Just Finished 2 TM lowers with the 80% percent arms easy jig, with no issues.

[nodixe]

I would like to see the jigs and lowers from elk creek manufacturing included in the list if anybody has any experience with them. They offer 80% armalite pattern and SR25 pattern lowers.

Sent from my SCH-I545 using Tapatalk