So I was just in the garage reloading .40 S&W on my Lee Classic Turret when I heard a funny noise that came from my press I thought I had popped a primer but that wasnt the case. I checked the round fully and saw no discernible damage or inconsistencies and so continued to finish that round. As I started the next round and got to the powder stage I noticed that the powder measure wasnt dropping any powder into the brass. It seems that my auto disk is somewhat stuck. It will move a bit forward but will not go back far enough in order to fill with more powder. I took off the powder measure and then put it back on but that did not seem to help at all. Anybody have any ideas on what could have caused this?
This is the press with the arm fully depressed.

Closeup of the disk when the lever is down.

Closeup of the disk when the lever is up.
This is the press with the arm fully depressed.

Closeup of the disk when the lever is down.

Closeup of the disk when the lever is up.

Comment