Unconfigured Ad Widget

Collapse

Trimmers

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • #16
    gunboat
    Veteran Member
    • Apr 2008
    • 3288

    Herter --

    Comment

    • #17
      CSACANNONEER
      CGN/CGSSA Contributor - Lifetime
      CGN Contributor - Lifetime
      • Dec 2006
      • 44094

      If you want the best, pay for a Giraurd. If you are only going to trim two calibers and you are willing to go a bit slower, get a couple K&P trimmers. They use a "V" style cutter and don't require deburring.
      NRA Certified Pistol, Rifle, Shotgun and Metallic Cartridge Reloading Instructor
      California DOJ Certified Fingerprint Roller
      Ventura County approved CCW Instructor
      Utah CCW Instructor


      Offering low cost multi state CCW, private basic shooting and reloading classes for calgunners.

      sigpic
      CCW SAFE MEMBERSHIPS HERE

      KM6WLV

      Comment

      • #18
        GeoffLinder
        Senior Member
        • Jul 2009
        • 2425

        Originally posted by Antihero47
        From what I've experienced the Dillon trimmer does square the case mouth however I've personally noticed and have heard from other users that the squared case mouthes do not need to be chamfered and debured once trimmed. I've seen perfect cuts with no burrs out of thousands of rounds and have taken cases I prepped with and without the chamfer debur process and noticed no difference in group sizes at various ranges

        The way I see it is I can size and trim brass and skip the chamfer and debur and bring my process from 2 steps to 1. But, this is just what I've experienced.
        Match grade bullets like Sierra SMK's and similar will be scratched from seating and even get ring gouged if you taper crimp and the case mouth is not chamfered. Any severe or uneven circumferential damage done to the jacketing on a bullet meant to fly really well will only be seen way, way downrange.

        This will not be easily noticeable using any simple group comparison process until you get past 500-600 yards and even farther. You would have to run hundreds of multi-round group comparisons through statistical reduction to even detect it at 200-400 yards and you may never be able to measure it at all at under 150 yards.

        It is a very small thing based on ever so slightly uneven drag around the projectile circumference and from projectile to projectile, but a small thing that folks striving for the utmost in long distance accuracy and wind bucking consistency do pay attention to.

        You are probably correct to not worry about it if you aren't looking for 6-700 yard plus ballistic consistency.

        Myself, when I put a high zoot match grade bullet like an SMK into a batch selected case over something expensive like Varget, I want to know the investment is being treated as it deserves to be

        Comment

        Working...
        UA-8071174-1