Knobs for Dillon Powder Measure

[LexLuther]

Ok, here is what you they look like at ACE. I like these because you can write on them with a sharpie. I numbered the bumps so I can keep track of how far I turn the nob, and I marked what direction increases the charge, so I dont have to keep guessing and testing. I bought 5 and will ship them to you for $3 each. You can see what I paid in the pictures below...Hell, I will throw one in for free if you buy a backpack.

The first picture shows the outside of the drawer, you want the middle drawer.


Second picture shows the sizes, you want the 5/16 size

[Lead Waster]

So we want the 5/16th ones, right?

[Chief-7700]

If I remember correctly the nut on the back of the Dillon powder measure is 7/16"

[Lead Waster]

OK, so then I should just check before buying one. LexLuthor's pic doesn't show 7/16ths in any of the bins.

[Chief-7700]

It is 7/16" just checked.

[anyracoon]

The Knobs from Home-Depot say 5/16"!

[LexLuther]

5/16th is the size your want from ACE.
PM me if you want one, I bought 5 extra while I was there to share since they are not in all Ace or HD stores.

[Mac Attack]

Mac Attack,

Can you please post a pic of your setup?

Thanks,
John

I will post one tonight. I am planning on ordering another one for my small powderbar.

[Spyduh]

I'm going to ace to look for the knobs. Hope I find them!

[LexLuther]

I still have 4 extra "ace knobs" if you cant find them, I will ship them to you for $3 each

[Mac Attack]

Here are the picks of my Uniquetech micro adjuster on my powderbar. It was easy to install and thus far has been pretty accurate to recreate a previous load. The micro adjuster came with a table that could be used to estimate loads. I have read that the table works very well though.

[Rwnielsen]

That thing's pretty cool

Will it fit the small bar too?

[Mac Attack]

Yes. It will fit any powder bar. I plan to buy a second one in the near future to use on my small bar.

[Rwnielsen]

Yes. It will fit any powder bar. I plan to buy a second one in the near future to use on my small bar.

This is the only one I know of, is this the same?

http://www.uniquetek.com/site/696296/product/T1267

[anyracoon]

Link for just the micro adjuster; http://www.uniquetek.com/site/696296/product/T1231