Squish your own jacketed 40/10mm

[manny]

https://www.youtube.com/watch?v=MBcZZsAdlVY

another installment on using dies (or dies you can get at a fraction of the price) you already have to make bullets you want with brass someone else was probably going to throw away.

Even if I do think the .40cal is an inferior round when compared to the others.
I got lots of mail from people wanting to know how to do it.

[stilly]

I would just buy a BT Sniper one step die that lets you drop a cast 158gr WC into a 9mm case that has been fired and make a 180gr .401 pill complete with primer still in the base.

But hey, it is fun going through these gyrations if you are not aware of the almighty and powerful BT Sniper...

[manny]

We do it cause we can! And the primer is still in the base of this brass.
Love your powder coated parade BTW, all gumballesque.

[stilly]

We do it cause we can! And the primer is still in the base of this brass.
Love your powder coated parade BTW, all gumballesque.

Well thank ya thank ya. It is nice to see other ways around the $465+ set of BT Sniper dies (for the cheap folks). You have made other videos similar to this that I got a kick out of too.

[Cheep]

You can use those 40's and make bullets for 44mag...

[manny]

You can use those 40's and make bullets for 44mag...

Those were 9mm luger cases we used to make into 40's. But we do use that nasty 40 cal brass to make .44 jacketed bullets...

https://www.youtube.com/watch?v=TC2Ad3k3kgg