357sig brass

[rman]

Looking for a good source for 357sig brass. Found some for $50-60/1k, any places have it less?

I plan to form some 40 brass to start, but have read about it being a bit short, thinner, and chambering on the shoulder or extractor vs. the mouth... from what I've read, none are really issues, but I do eventually want to load them hot.

Planning to use 115gr .355 hornady XTP. Not sure on powder yet, unique is probably too big. CFE?

Sent from my Nokia 5160 using Snake

[rman]

thanks. not so much a WTB post. more of a "where do you guys get your brass?" post. I was on my phone and my wife was staring at me... so I may have worded it poorly

[MrElectric03]

That sounds like a pretty fair price to me. I buy it when I see it for a good price but it's not all that easy to find, especially in bulk.

[stilly]

just look for ONCE FIRED BRASS in google and you will find brassman and brass monkey and a few others that will sell once fired brass for pretty cheap.

There is always gun broker.

http://www.gunbroker.com/Reloading-Supplies/BI.aspx?Keywords=.357+sig

A couple of auctions there seem pretty good. 4k for $200 for THAT cartridge is pretty decent. usually folks snap up the 10mm/357 sig/.380 stuff and sell it for ridiculous prices.

But because it is shouldered, it is a PITA to deal with so who wants it? Gun broker is your friend. at .06 a shell, it does NOT get much better.

[rman]

some decent prices om gunbroker, thanks.

the site i found was $52 shipped for once - fired, cleaned and polished... not bad!

Sent from my Nokia 5160 using Snake