Tweet
Happened to me again last night - told the wife, "Quite by
accident, honey!" ... but it was worth it!
Was sitting around here reading the instruction manual
for our RCBS progressive and figured that I could
probably knock out just the instillation in an hour or two
- which I did - and then go to bed. Of course, by then I
'just had' to run off a few 'test runs' - did the obligatory
adjustments and made the obligatory mistakes - finally,
got the little 'munitions factory' up and humming along at
the advertised 650/hr. rate of production and by the time
I had set up and made a .44 Mag. dies plate and run that
one, too, it was about 5:30AM.
... mumbling something about "being too old for this kind of
all night stuff anymore" I finally got to bed for an hour's worth
of shuteye.
Alarm went off at 6:30AM - fixed the wife's breakfast and got
her off to school - I'm such a good little house husband -
and now I'm waiting for the range to open at 10!
... and yes, it does out perform the Dillion - the primer strips
and swapable pre-adjusted dies plates make it a whole lot
faster!
I picked up three plates and am going back for about five more
tomorrow!
However, I think today I have a monumental clean up job scheduled
for our 'little bench!'
accident, honey!" ... but it was worth it!
Was sitting around here reading the instruction manual
for our RCBS progressive and figured that I could
probably knock out just the instillation in an hour or two
- which I did - and then go to bed. Of course, by then I
'just had' to run off a few 'test runs' - did the obligatory
adjustments and made the obligatory mistakes - finally,
got the little 'munitions factory' up and humming along at
the advertised 650/hr. rate of production and by the time
I had set up and made a .44 Mag. dies plate and run that
one, too, it was about 5:30AM.
... mumbling something about "being too old for this kind of
all night stuff anymore" I finally got to bed for an hour's worth
of shuteye.
Alarm went off at 6:30AM - fixed the wife's breakfast and got
her off to school - I'm such a good little house husband -
and now I'm waiting for the range to open at 10!
... and yes, it does out perform the Dillion - the primer strips
and swapable pre-adjusted dies plates make it a whole lot
faster!
I picked up three plates and am going back for about five more
tomorrow!
However, I think today I have a monumental clean up job scheduled
for our 'little bench!'
I have a Hornady LnL and i love how quick i can change calibers, now all i need is an auto case feeder.
Comment