Reloading cleaning brass

[edgerly779]

Put in ammo reloading.

[Perry67]

I have never had to resize brass cleaned in either a vibratory or rotating tumbler. I clean my 9.3x74R brass in one and haven't had any problems (it's really thin and easy to deform). If you're going to switch to a rotating tumbler I would look hard at using stainless steel media. I think that the chances of deforming the case mouth would be nonexistent, even with very large cases, and it really cleans brass.

[xrMike]

I refuse to read this thread since it's not in the proper forum.

[ohsmily]

I refuse to read this thread since it's not in the proper forum.

Stand strong!

[Robert1234]

Adding steps to the reloading process is something I want to avoid like the plague.

For anything, I clean (wet or dry), decap/size. Then if it's rifle bars, I trim. Then to loading

Pistol brass gets right to the next station (bell case,, add powder), then seat bullet, then crimp.

I'm not looking for sparkling brass, I just want it cleaned and loaded.

I'd much rather be shooting than reloading.