AR-180 ?

[General]

My favorite AR

[ElvenSoul]

Have you ever heard the song?

https://youtu.be/MIvsFuk6RuE

[isplice]

Have you ever heard the song?
https://youtu.be/MIvsFuk6RuE

You love that song, don't you.

[ElvenSoul]

You love that song, don't you.

It just amazes me

Ak's have songs and poems.
AR 15/M16 umm does hate mail count?
AR18 has this one song.

[BRC]

Yep - right at 30-1/4" overall. I'll post pics of that too. That was also the reason for removing the original shorter 3-prong Flash-hider and installing one from Damage Industries, that keeps the look as best as possible.

How are you locking the stock when folded to the side? Did you have a
pin installed on the lower receiver as per the original ..?
Or is it now locking at the fulcrum...?

[isplice]

Wait for the JB Weld to harden up about 6 hours or so, then take a Popsicle stick and texture it. Nobody will be able to tell the difference. Check out my AR-180 in the previous thread to see the weld. Or you could make it really sloppy to copy Sterling!!

[The Gleam]

Wait for the JB Weld to harden up about 6 hours or so, then take a Popsicle stick and texture it. Nobody will be able to tell the difference. Check out my AR-180 in the previous thread to see the weld. Or you could make it really sloppy to copy Sterling!!

Posted the complete work-up of the rifle, and included photos of most all the stuff I mentioned above in this thread - here:

http://www.calguns.net/calgunforum/s....php?t=1170130

[sigstroker]

Wait for the JB Weld to harden up about 6 hours or so, then take a Popsicle stick and texture it. Nobody will be able to tell the difference. Check out my AR-180 in the previous thread to see the weld. Or you could make it really sloppy to copy Sterling!!

To make a convincing copy of a Sterling be sure to put it on crooked and/or out of spec so it holds the magazine too low so it jams a lot.