Need good scope 1" rings for Marlin model 60. <update on post 26>

[2shotjoe]

Couldn't find any rings by the model number. There any like the Nikon m223 scope rings? I think the rail is 3/4.

Sent from my DROID RAZR using Tapatalk 2

[Kestryll]

Pick your color!

http://swfa.com/Millett-22-Caliber-Scope-1-Rings-C1195.aspx

[Chaos47]

UTG 1 piece integral for dove tail

[Kestryll]

UTG 1 piece integral for dove tail

Good call, the Marlin dovetail is kind of soft and prone to walking.

http://www.amazon.com/UTG-Airgun-Medium-Profile-Integral/dp/B002TUSJVQ/ref=pd_sim_sg_1

[Chaos47]

I have it on my Marlin 795, it is rock solid and it's a good value too.

[roushstage2]

Another vote for the UTG mount. Solid.

[model63]

A picture of my UTG mount is in the below if you are curious. It is the only thing that held solid for me after two sets of rings, clear nail polish around the dovetail (I was desperate to get it to stop walking)...

http://www.calguns.net/calgunforum/showthread.php?t=433052&highlight=scope33052&highlight=scope

[2shotjoe]

perfect, thanks. my current rings did walk off, gave me tons of problem when i was trying to zero the scope Sunday.

[NOTABIKER]

wall mart center point 60 Bucks. dove tail ready. i put one on my savage 64 dove tail simi auto and it is great. or spend lots more money.

[ejhc11]

If you have rimfire grooves then check these out - USA made

http://www.bkltech.com/

[Chaos47]

If you have rimfire grooves then check these out - USA made
http://www.bkltech.com/

I've seen these ones suggested before and they look nice...
I just don't get why you would spend apx 3x as much to get those over the UTG...

[bombadillo]

For rimfire, the UTG stuff I've used in the past has actually been great. Wouldn't trust it for centerfire much though. Had an AR grip once and that was it from them.

[2shotjoe]

Good call, the Marlin dovetail is kind of soft and prone to walking.

http://www.amazon.com/UTG-Airgun-Med...ef=pd_sim_sg_1

bought, thanks. was under 20 shipped, finally had an use for those 2 ten dollar gift cards i had for Amazon.

[ojisan]

You can also get this style mount from Gamo and Centerpoint through Pyramid Air.
The same dovetail dimensions are used on air guns and .22s.
These are the only type of mounts I have found that will stand up to the recoil of the springer 1,000FPS air rifles.
These air rifles are actually tougher on scopes than gunpowder rifles because air gun recoil goes both ways.

[Izzy43]

bought, thanks. was under 20 shipped, finally had an use for those 2 ten dollar gift cards i had for Amazon.

Get some blue locktite and use on the screws to the dovetail, wait 24 hours and it will be rock solid. The blue locktite will allow you to remove the screws if needed. DO NOT USE RED LOCKTITE!!!