My 243 AR10

[StoneTower]

How much did that set you back if you dont mind me asking. And is that a 22 inch barrel or a 22 inch gas system?

It has to be a 22" barrel if it was cut down from an ArmaLite AR-10 243T as they were 24" barrels.

He probably has about $600 in the upper, $149 in the Vtac FF handguard, $600 in the completed N6 lower (unless he has an aftermarket trigger) and I am guessing $200 in gunsmith work to cut down the barrel. I don't know how much the scope cost or the mounts. I would say he has $1549 in the basic rifle (no mags, no scope). We will see how I did when he answers.

[thmpr]

Clean, simple and all the right parts! Very nice. I will go with the 6.5 creedmoore caliber.

[rem7600]

Very nice! alot of people dont give the 243 win credit it deserves,very accurate, long distances same goes for the rem6mm .Very good job wish it was mine!

[Blacktail 8541]

It has to be a 22" barrel if it was cut down from an ArmaLite AR-10 243T as they were 24" barrels.

He probably has about $600 in the upper, $149 in the Vtac FF handguard, $600 in the completed N6 lower (unless he has an aftermarket trigger) and I am guessing $200 in gunsmith work to cut down the barrel. I don't know how much the scope cost or the mounts. I would say he has $1549 in the basic rifle (no mags, no scope). We will see how I did when he answers.

Not to bad a guess!
$725 for the upper, new unfired from an Ar15.com member.
$150 for the carrier. It was bought as componets and assyembled by me.
$160.00 w/shipping for the VTAC
$80.00 For gun smith work.
$67.00 for the gas block.
$600.00 for completed lower, + 279.00 for Guisele trigger inbound.
$30.00 for scope bases.
$140.00 for scope rings.

Total = $1952.00 + 279.00 for trigger = $2231.00

Scope 650.00 Will be sending to leupold for M1 dial conversion = 160.00

Total = $2762.00

There are a few misc expenses not included.