New Glock break-in ?

[HighLander51]

Break in starts at round 1 and continues to over 100K rounds, or until you trade or sell..... Lube it up correctly (search You tube) are run it for at least 5,000 rounds before cleaning, repeat...

[Shenaniguns]

The copper grease acts as a lapping compound. And yes I am correct, that is what I was told directly from Glock.

It depends on who you speak to at Glock, if it was truly a lapping compound it would be applied a little more evenly and consistently.

[Shenaniguns]

This is what it is btw from loctite http://www.midwayusa.com/product/723...pper-1-oz-tube

[fullspeed1]

My break in consisted of dropping my 19 on the concrete.

[HighLander51]

My break in consisted of dropping my 19 on the concrete.

Thats a good start, I set my first G19 on fire.... It runs fine after replacing all the plastic parts and springs, but the smell is still there.

[Jet Setter]

Those are ready to go out of the box. They have polygonal rifling.. you don't break that in, just don't send lead through it.

+1. Just clean then enjoy.

[Plisk]

It depends on who you speak to at Glock, if it was truly a lapping compound it would be applied a little more evenly and consistently.

Every Armorer instructor and Support Tech. I've asked have given me the same answer.

It's not truly a lapping compound, as I said the copper grease acts as one.

[MrExel17]

My Glock ran ready to go! Never heard of such thing!

[SonofWWIIDI]

Wipe down, lite lube, enjoy!

[foreppin916]

Iv fired a little over 3000 rounds through my 19. The only time I had any problems was with reloads. The bullet was not seated properly and jammed up the gun. Could cycle the slide at all. Had to very carefully take a rubber mallet and wack the thing open with a live round in the chamber