ETS Glock Mags "bias loading"

[hambam105]

Hopefully all works out for the OP. And the rest can heed this as a warning.

[smallwavebill]

Bought 1 ets during freedom week and it holds 1 less than advertised and caused jams,, ( gun runs flawless with OEM, and magpul)

[beanz2]

I have the same problems with my airsoft magazines. BTW they cost the same as ETS magazines.



It reminds me of ARF.com's hilly billy:




.

[boopiejones]

I have the same problems with my airsoft magazines. BTW they cost the same as ETS magazines.



It reminds me of ARF.com's hilly billy:




.

[SkyHawk]

An exception to this could be Mec-Gar. They make a lot of the OEM mags so their "aftermarket" stuff is basically the same as OEM. Maybe a different base plate or different color follower.

And Metalform.

[NorCalGlock9]

I’ve used ETS 10,15,17 & 31 rounders and have had no issues yet. I must be lucky. They’re just a PIA to get the last round in

[sbo80]

I have a whole pile of ETS 10-rd for both a G19 and G17 and never had any issues, shot plenty of matches without issue. I use an uplula. Only thing I am noticing is the outsides getting rough from too much dropping in the dirt, a couple don't drop free as cleanly as they used to. I haven't tried polishing them back up though. I didn't hesitate to pick up standard size ones during freedom week. But I'll also be honest, I keep a OEM glock mag loaded when it's in the nightstand.

[plumbum]

I have 3 ETS mags for my G26 and they’ve always run fine - but bring short they don’t have much room to wiggle like that.

[roostersgt]

An exception to this could be Mec-Gar. They make a lot of the OEM mags so their "aftermarket" stuff is basically the same as OEM. Maybe a different base plate or different color follower.

Could be an exception, but I use my pistol at work and my life depends on magazines functioning every time. The only magazines one can count on the most are the ones from the manufacturer. Others might be okay for range work, but why risk failures when for a little more change you can get the "real" ones? Saving a couple of bucks on the very part that causes the most failures to feed makes no sense to me.

[steelholder]

Same BS happened on my 15 rounders..

[zan101]

Sootch00 does not do reviews, he does advertisements.

I once believed he was doing reviews, then I noticed he never criticized any product. Everything was great. So stopped watching his videos.

[steelholder]

[Yodaman]

You must be bias too! Haha


Sent from my iPhone using Tapatalk

[steelholder]

These **** magazines seem to be

[dave85620]

My ets mag I bought had what looked like grease inside the mag walls. This mag is unused. Have you guys who had problems seen the same? Btw