Help Please: RMR not fitting Glock Slide

[caliguy93]

Take a small needle file and slowly file away. Honestly if it were me, I’d probably use a small round needle file on the rmr hole and mounting plate hole instead of the slide. The little amount won’t even be noticed and will allow the screw to go straight down while still maintaining a nice tight lock up. You could probably remove the amount necessary in a few swipes. Just gotta be brave

[ducatiti]

Take a small needle file and slowly file away. Honestly if it were me, I’d probably use a small round needle file on the rmr hole and mounting plate hole instead of the slide. The little amount won’t even be noticed and will allow the screw to go straight down while still maintaining a nice tight lock up. You could probably remove the amount necessary in a few swipes. Just gotta be brave

I'm not brave enough. I'd rather have someone do this for a fee. I don't want to touch the brand new RMR for sure in the event I may use it for another firearm. I purchased a 1 MOA anticipating to enter the AR world in the very near future=)

[JTROKS]

[Nephthys]

good idea to not mess with the rmr, I was thinking the same, in case you wanted to mount it to something else, like...

...anticipating to enter the AR world in the very near future=)

it begins...

[Paperchasin]

I'd sell the slide off with the disclaimer and get yourself another slide.

[AGFNTB]

The problem is the top side where the countersunk holes are. If the holes in the slide are not exact to the holes in the RMR (center to center) the tightened screw would put stress on the RMR.