I have a Springfield Loaded Stainless Target in 45ACP, NM serial number on the frame.
It has functioned fine with hardball, hollowpoints, semi-wadcutters from the get-go, there wasn't really an unreliable jam-happy break-in period.
Overall, it is very well put-together. They utilize many manufacturing shortcuts to reduce cost, and I think that's fine. It is done judiciously, not affecting performance or reliabilty, at least not that I can tell.
Many of the small parts were metal injection molded, and while none of them have failed, I replaced the hammer and sear with STI parts.
The ejector is not secured with a crosspin, if that matters to you. I think it is press-fit with Loctite added. I have over 1,000 rounds through the gun and the ejector is still firmly stuck in there good, but I will be replacing it soon with an extended ejector. I probably won't pin the new ejector either, just red Loctite.
It has functioned fine with hardball, hollowpoints, semi-wadcutters from the get-go, there wasn't really an unreliable jam-happy break-in period.
Overall, it is very well put-together. They utilize many manufacturing shortcuts to reduce cost, and I think that's fine. It is done judiciously, not affecting performance or reliabilty, at least not that I can tell.
Many of the small parts were metal injection molded, and while none of them have failed, I replaced the hammer and sear with STI parts.
The ejector is not secured with a crosspin, if that matters to you. I think it is press-fit with Loctite added. I have over 1,000 rounds through the gun and the ejector is still firmly stuck in there good, but I will be replacing it soon with an extended ejector. I probably won't pin the new ejector either, just red Loctite.

Comment