RifleGear Uppers now available!

[shark92651]

RifleGear is proud to announce the introduction of our very own line of high quality complete AR-15 upper receiver groups. Every RifleGear complete upper is assembled using the finest parts and materials and subjected to industry leading quality control tests. Features include chrome-lined cold hammer forged barrel, full-auto bolt carrier group and charging handle, HP and MPI tested barrel and bolt, and plastic hand guards.

Currently in stock are 16" Carbine, 16" Mid-length, and 14.5" Carbine w/perm flash-hider (limited availability on 14.5").

RifleGear Complete Upper Receiver Assemblies - prices start at $599.00




Barrel

• 4150 Cold Hammer Forged
• MPI Tested
• Pressure Tested (HPT)
• Chrome Chamber & Bore
• 1:7 Rifling Twist
• 5.56mm Chamber
• M4 Feedramps
• F-MarkedFront Sight Base (FSB)
• Taper Pins at FSB
• Parkerized Finish Under FSB

Bolt

• MPI Tested
• Pressure Tested (HPT)
• Shot Peened Bolt
• Black Extractor Spring Insert
• Properly Staked Gas Key
• M16 Bolt Carrier Style (Full Auto)

Lifetime Warranty
RifleGear complete upper receivers carry a lifetime warranty to the original purchaser, against defects in original materials and workmanship. If your RifleGear complete upper shows signs of such defects, RifleGear will repair or replace your complete upper at no charge to you. RifleGear does not warranty product damage caused by normal wear and tear or resulting from the installation of other manufacturer's products. Please retain your sales receipt as proof of purchase.

[Cokebottle]

Can you do them in a 1:9 with a low-profile gas block and quad rail?
Thinking about both a 20" and a 14.5"... probably going to be a couple of months.

[shark92651]

There are currently only available in 1:7 twist. We will be introducing new standard models over time, and of course we can customize the current models with any of the rails and gas blocks that we have in stock for an additional charge.

[MotherGunner]

Wow, you have actually caught my eye with these impressive specs for the price. I have been looking for a carbine upper that is cold hammer forged (I believe BCM doesnt even offer a cold hammer forged carbine length yet. ) Price is alot better than a DD upper.

And now to sell the wife on it... =/

[johnrunner89]

Nice! I'm gunna have to stop by the shop to check these out!

[robertjq]

Sweet! Lovin the logo's!!!!!

[aplinker]

Impressive specs and price. A great option.

[jrau13]

Impressive specs and price. A great option.

+1 great deal guys!

[BONECUTTER]

Must....not....buy....14.5.......

damn you.....

[CHS]

Just as good, if not better than a BCM. FOR LESS!

ROCK ON!

[johnrunner89]

Any hope we will see a .308 upper soon too?

[fcr]

sweeeet.

[MotherGunner]

I think I am gonna say screw it for the BCM upper I was getting and go with Riflegear. Hope the wife agrees! *fingers crossed*

[Jeffu]

great job guys

[xm177]

Congrats. I've gotta swing by to see one of these in person.