Tavor bullet button?

[Stamatos]

I can't wait for these to be stocked! Let's hope we aren't paying more that $2100 for them

[Prince50]

Dealers have been shipped.

The brake is one length. I will look into a shorter unit to satisfy the 18 inch without extra length.

Retail price is less than $60 for the button alone.

Darin

[seainc]

Which dealers have them? I checked RifleGear and OC Armory both don't have it.

[Prince50]

Call both, and they can get them for you. Riflegear has them in stock.

OC can order them, but I am not sure that they have done so yet. Do you need the extended FH?

Darin

[Prince50]

North County Firearms has them.
760-798-7300

D

[jonnietyler]

I bought a Tavor bullet button at North County Firearms. I was able to get it installed on my Tavor, however, one of the holes on the shroud is drilled too small for the set screw.

It seems to work fine with only using 2 of the large set screws and the one small set screw.

What size drill bit should I use to get the 3rd set screw to fit?

[esp1]

Does installation require drilling into the plastic of the Tavor's stock ? ?

[tonelar]

I bought a Tavor bullet button at North County Firearms. I was able to get it installed on my Tavor, however, one of the holes on the shroud is drilled too small for the set screw.

It seems to work fine with only using 2 of the large set screws and the one small set screw.

What size drill bit should I use to get the 3rd set screw to fit?

Doesn't the shroud just thread on? Or are you talking about the maglock?

[esp1]

Doesn't the shroud just thread on? Or are you talking about the maglock?

The shroud and the maglock are different names for the bullet button. I think you are talking about the barrel extension just threading on.

I was asking if you need to drill into the Tavor's plastic in order to install the bullet button shroud which I think comes with four threaded pins/screws. Or if the holes in the Tavor's plastic stock already line up to the holes in the bullet button shroud.

Then my next question is if screwing in the bullet button's threaded pins will "bite" into the plastic or do the thread in the pins catch/engage into each other or a different metal piece.

[jonnietyler]

The screws thread into the shroud, NOT the rifle. The screws go into pre-existing holes on the Tavor. The holes around the trigger area are used to index the screws.

[esp1]

The screws thread into the shroud, NOT the rifle. The screws go into pre-existing holes on the Tavor. The holes around the trigger area are used to index the screws.

Ok. . I see. . . simple but genius !

[thmpr]

What is the difference between Prince 50 and Raddlock Tavor BB besides price?

[esp1]

raddlock you pry open the side mag release

prince is more kinda like the AK bullet button but works a lot easier due to the design of the tavor mag release

[esp1]

raddlock you pry open the side mag release

prince is more kinda like the AK bullet button but works a lot easier due to the design of the tavor mag release