Below is the all the hardware you need to start reloading 9mm or 45acp. (Except for Primer, Bullets, Powder, Brass) Bought it from a friend but never used it.
The press is currently set up for 45acp so you could assemble it and start reloading right off the bat.
*You will need to buy a couple of bolts 1/2" (or 5/6"per Hornady) bolts that are 2 3/4" in length to mount the loader to your surface*
What's included:
-Hornady Lock-N-Load AP Press Loader (Original box and paperwork included)
-9mm and 45acp die kits
-2 RCBS powder check dies
-RCBS Manual Powder scale
-Extra Hornady Powder Dispensing Set
-Tumbler set
-Tumbler media (walnuts)
-Hornady stuck case remover
-Primer Tubes
-Case Lube Kit
-RCBS Rotary Case/Media Separator
-Lee Universal Decapping Die
-2 RCBS Lock Out Dies
-Plastic Ammo Boxes
-A few more smaller accessories I haven't inventoried yet. Message me directly with any questions you may have!








First person to PM that they'll take it gets it. If they bail then the next person gets it, and so on.
The press is currently set up for 45acp so you could assemble it and start reloading right off the bat.
*You will need to buy a couple of bolts 1/2" (or 5/6"per Hornady) bolts that are 2 3/4" in length to mount the loader to your surface*
What's included:
-Hornady Lock-N-Load AP Press Loader (Original box and paperwork included)
-9mm and 45acp die kits
-2 RCBS powder check dies
-RCBS Manual Powder scale
-Extra Hornady Powder Dispensing Set
-Tumbler set
-Tumbler media (walnuts)
-Hornady stuck case remover
-Primer Tubes
-Case Lube Kit
-RCBS Rotary Case/Media Separator
-Lee Universal Decapping Die
-2 RCBS Lock Out Dies
-Plastic Ammo Boxes
-A few more smaller accessories I haven't inventoried yet. Message me directly with any questions you may have!








First person to PM that they'll take it gets it. If they bail then the next person gets it, and so on.

Comment