P226 Dark Elite 9mm + Accessories, Rare/Off-Roster, Concord

[austen27]

[austen27]

BTT

BTT

[austen27]

BTT

BTT

[Sigman1960]

darn if it wasn't so beat up I would prob buy it.

[EliteCorp]

Pm sent about Mags.

[austen27]

[austen27]

BTT

[Cpl_T-Pot]

P226 Dark Elite 9mm + Accessories, Rare/Off-Roster, Concord

Nice gun to be had here..............


Black oxide controls about $120 from robar plus shipping
TiCN carbon black slide about $80 dollars plus shipping
Re anodizing Allegheny arms $125 dollars, he's down for a few months though. Plus shipping. International hardcoat does private party re finishing but you must have an FFL for some reason per my inquiry regarding a beretta frame.


$325 plus about $150 in shipping costs to get it basically back to factory. Not sure what sig will charge, but I'm thinking about that if not more, but they will replace springs and what not.


$850 plus $325 turns to be about $1200 after much down time with the gun.

On the other hand for those who are interested in it, you may choose to shot the crap out of it and take some classes with it. And if you like the platform, buy a new one later.

Side note, a complete cerakote job could be had for as little as $195. That elite series stuff is holding up on my Beretta rails after 300 rounds and sitting at home racking the s*** out of it.

Good luck, this comment is by no means to be negative.


Sent from my iPhone using Tapatalk

[austen27]

[Cpl_T-Pot]

Nice, you may also want to check into Darin at D&B custom coatings, he offers a complete job at a much cheaper rate if you disassemble the firearm yourself. He's located in Napa and is certified. Got my Beretta frame done in a custom elite series smoke/midnight mix.


Sent from my iPhone using Tapatalk