WTS - Tactical Machining 1911 80% Frame, jig and tooling

[MooneyFWD]

I decided to tackle a different project.

So here is what you get to complete a TM 1911 80%.

1x Tactical Machining Blem 80% 1911 receiver

http://www.tacticalmachining.com/1911/1911-frames/blem-80-tm-recon-frame.html

1x Tactical Machining 1911 jig

http://www.tacticalmachining.com/1911/1911-jigs/1911-80-percent-side-plates.html

Tooling - Everything needed to machine the lower frame except for the ball end mill. (both drill bits and key seat cutter)

Everything is still sealed as it came from TM plus the tooling from McMaster. I don't see any "blems" on the receiver, but it was indeed purchased as a blem from TM.

$230 shipped

I figured I would try to help a fellow Calgunner out before submitting for return. I have about a week left to return it. GET IT WHILE IT'S HOT!

[img][img]

[Darklyte27]

Where did you get the bits and key seat cutter from?
where you located?

[MooneyFWD]

Where did you get the bits and key seat cutter from?
where you located?

Bits and key seat cutter are from McMaster. Located in Long Beach.

Also, I know I don't have a lot of posts or trader feedback. I use the same name on eBay if you'd like some references.

[Darklyte27]

just saw fedex shipping is 15$ on top of that 228$ at TM, ill take it!

[MooneyFWD]

just saw fedex shipping is 15$ on top of that 228$ at TM, ill take it!

PM sent. Darklyte27 has dibs. SPF.

[MooneyFWD]

Sold!