FS: old style 80% AR 15 lower

[saki302]

I can't remember who made this thing- it was made close to a decade ago, before they switched to the solid FCG pocket type.

It requires ALL the holes to be drilled (bolt release, pistol grip, FCG, front/rear upper pin, retaining pins, etc.), and requires the buffer tube hole be reamed and tapped.

***There's one catch***- when I got it, the buffer tube hole was already jacked up a bit.. It STILL needs to be reamed to full diameter, then tapped, but it has a light (BAD!) ream job done by hand. It is not yet full diameter, so it should be fixable (carefully!) on a mill or drill press. But you buy it as-is, like I did.

SOLD and shipped to aceatm1nd

[jericho89]

Just an FYI that is a Tannery Shop 80% and if you are lucky you can find someone with one of the jigs to complete it.

[saki302]

That's it- Tannery shop.

I don't need any more AR lowers, which is why it's for sale. Someone with a mill and blueprint should be able to finish it just fine also. I spoke to Gabe at Arms Specialty (Orange, CA), and he said he could finish this type of lower (but is not set up for it at the moment).

-Dave

[aceatm1nd]

Will take this per our discussion