WTS used Sadlak Mount Aluminum WITHDRAWN

[galabomber]

I have a used aluminum Sadlak mount for sale. Hardest part of install was the stripper clip guide, but cake after. I'm selling because I find my M1A is out of spec, but the mount is solid. Mounts tight with 3 points of contact. It has signs of wear, where cases eject, but shouldn't effect function. I hate letting it go, it's one of the top mounts out there. It has all the hardware to install, including the literature and inspection kit. I'm located in the Elk Grove/Sacramento area.
Asking $120, $125 shipped. WITHDRAWN
Possible trades, factory 308 FMJ and/or factory or CMI M1A rebuilds. Thanks!
(Sale is for Sadlak Mount only!)

[damon1272]

Contact sadlak as they can assist you in getting the mount on there properly.

[galabomber]

bump it

[drkphibr]

Contact sadlak as they can assist you in getting the mount on there properly.

+1 ^

Sadlak is the ONLY M1A scope mount manufacturer that will custom modify the mount to fit an out of spec receiver. Everything to take the measurements is included in the original packaging (it's the paper with the pins in a bag stapled to it. The service is $50 though).

It also looks like your cam washer may not be installed correctly (which could be part of your problem) as when you install the washer with the "arm" beginning at the 9:00 position (and hand tighten the hex screw + 1/8 turn more), the "normal" position for the arm after it's tapped to close the gap of the stripper guide is to have it in a position between 11:00 and 1:00. Your cam washer arm is at ~4:00. Just a thought.