Tweet
I have this CMMG upper receiver complete with bolt/charging handle purchased in '08 before the election craze with <1000 rounds of use.
CMMG 1:7 Chrome Lined 16" (14.7" w/ Perm A2 Hider) Upper:
*certified 4150 chrome-moly vanadium steel
*5.56x45 NATO chamber
*1:7 twist
*Hard chrome lined chamber and bore
*M4 feed ramps
*11 degree recessed target crown
*F marked forged front sight base
*Parkerized Barrel including under the front sight base
*A2 Flash hider installed with Peel washer (hider is pinned, welded, and what looks like re-blued so as to hide the pin hole)
*Forged A3 upper receivers are T marked and have extended feed ramp cuts *(M4 ramps)
* Midwest Industries 4 Rail Handguard with rail covers
Here's a few pictures of it, I tried to get a few good ones of the bolt group to show the amount of wear (not really much). There's a scratch by the ejection port from when a screw driver was used to remove a shell that failed to eject from the chamber (due to dirty chamber, which has since then been thoroughly cleaned of course). There's a partial picture showing that the barrel is indeed a CMMG 556 NATO barrel as well.
Looking for $420 firm (SOLD). I wish I could go lower but I'm looking into buying a house this month and I'm strapped for cash at the moment.
Thanks for the interest. You can PM me if you'd like to purchase it. I can meet up in Livermore and Dublin in the evenings after 530PM.
I'm not considering shipping at the moment but I will open this option up later in the week.
-Marcus
CMMG 1:7 Chrome Lined 16" (14.7" w/ Perm A2 Hider) Upper:
*certified 4150 chrome-moly vanadium steel
*5.56x45 NATO chamber
*1:7 twist
*Hard chrome lined chamber and bore
*M4 feed ramps
*11 degree recessed target crown
*F marked forged front sight base
*Parkerized Barrel including under the front sight base
*A2 Flash hider installed with Peel washer (hider is pinned, welded, and what looks like re-blued so as to hide the pin hole)
*Forged A3 upper receivers are T marked and have extended feed ramp cuts *(M4 ramps)
* Midwest Industries 4 Rail Handguard with rail covers
Here's a few pictures of it, I tried to get a few good ones of the bolt group to show the amount of wear (not really much). There's a scratch by the ejection port from when a screw driver was used to remove a shell that failed to eject from the chamber (due to dirty chamber, which has since then been thoroughly cleaned of course). There's a partial picture showing that the barrel is indeed a CMMG 556 NATO barrel as well.
Looking for $420 firm (SOLD). I wish I could go lower but I'm looking into buying a house this month and I'm strapped for cash at the moment.
Thanks for the interest. You can PM me if you'd like to purchase it. I can meet up in Livermore and Dublin in the evenings after 530PM.
I'm not considering shipping at the moment but I will open this option up later in the week.
-Marcus
Comment