Shooter's Workstation

[trago]

Shooter's Workstation, Quality glued, screwed and tattooed (glued Lamello Euro wafer joiners and toe-screwed) solid maple and birch plywood faceframe construction cabinet. Assembled unit measures 5' long x 2' deep x 6' tall. Solid 1 3/8" finger-jointed maple top set at 31" off floor allows use of standard kitchen table/desk/computer work station chair. Left drawer base unit has three 3/4" plywood drawers (1/2" ply bottoms) with Euro pattern ball-bearing concealed soft close guides (key locks on two bottom drawers). Recessed & re-enforced knee-space shelf handles bulk bullets, brass, powder; also is set off rear wall to clear wall receptacle. Unit recessed at rear floor area to clear baseboard and allow setting tight to wall. Three solid oak/mahogany dove-tailed removable cubby drawers up top left for small tools. Electrical receptacle (h.d.) on counter allows easy hook-up for digital scale, Dremel, etc. Unit comes with 5' power core and plugs into standard 120v. wall receptacle. Back splash area is 1/4" pegboard (comes with 32 piece hanger kit) for displaying commonly used tools. Upper unit has open bookcase right (no door to interfere with scale mounted powder measure) and center/left compartments with glass centered, key lock door on each and soft close hinges (can't be slammed to break glass). All three comps. have one adjustable shelf. Top soffit unit has three Xenon task work lights controlled by switch at receptacle below. Xenon bulbs available at Home Depot. Soffit has removable re-enforced 1/2" plywood top allowing storage inside soffit. Top of soffit can be used for open storage as well. Unit disassembles into four components (base drawer/knee shelf/rt.end panel, maple counter top, cubby/back splash/bookcase, soffit) with six 1/4" bolts. Nail bar is provided in base unit and soffit for permanent attachment to wall. This unit is big enough to work on long guns and yet small enough to go down a house hallway into a bedroom or multi-use room. I am an old Kalifornia licensed cabinetmaker and this is built like a brick----house! I currently have the cherry stained one in the photo and the adjacent Hunter green stained one off to the left available. I can match existing stain or any paint store latex paint chip for additional charge. These units will look good in any house. I currently build about four of these a month. Accessories in staged picture (press, powder, scale, manuals, tools, etc, not included). Pick-up price at my shop in Red Bluff is $1,395.00.

[MR2Chuck]

Beautiful.

[Bizarro]

That is nice....wish I had the cash.