LWRC LWRCI IC ambidextrous mag release

[Apec]

These are OEM/factory ambi mag releases for the LWRC IC series. New and NEVER installed. These *might* work on other AR15 lowers, but I do not guarantee it.

ALL SOLD, thanks for looking Right side magazine release buttons/springs are NOT included. See picture.

[ProlificARProspect]

Can you confirm on a spare mil spec lower for compatibility?

[flyrick]

AMBI SELECTOR

TAG for later after holiday sale ;

[simon129]

I'll take one pm sent

[Glimmer3]

I will take one pm sent

[Aries64]

Not without machining

Can you confirm on a spare mil spec lower for compatibility?

"No" and "Yes". "No" because a MIL-Spec pattern Lower isn't machined to accept the LWRC M6IC Ambi Magazine Catch/Release. On the LEFT HAND side of M6IC Lowers the channel for the Magazine Catch/Release is enlarged, "squared-off", and open at the rear, allowing the "paddle" of the M6IC Magazine Release to sit near flush with the vertical bar on the magazine well of the Lower and to pivot when the paddle is pushed.

"Yes", it could work if the LEFT HAND side of a MIl-Spec Lower was machined to the correct dimensions to accept LWRC's M6IC Ambi Magazine Catch/Release.

See below for photos of a MIL-Spec LWRC M6 Lower and two (2) photos of M6IC Lowers. The first photo shows an LWRC M6 MIL-Spec Lower, the second photo is of an LWRC M6IC Lower without the M6IC's Ambi Magazine Catch/Release (California-legal for use by lowly civilians in California). The third photo shows an M6IC Lower with the Ambi Magazine Release installed.


LEFT HAND side of M6 MIL-Spec Lower (standard Magazine Catch Channel:


LEFT HAND side of M6IC Lower. Note the enlarged, "squared", and open-ended Magazine Catch/Release Channel (M6IC Ambi Magazine Catch/Release not installed):



LEFT HAND side of M6IC Lower. Note the enlarged, "squared", and open-ended Magazine Catch/Release Channel (M6IC Ambi Magazine Release installed):



Keith