Tweet
Selling a Lee two die set for 5.56x45mm / .223 in good condition. About 1000 pieces of brass were ran through these dies. I cleaned out the dies for resale.
Note: The de-caping pin is slightly bent (a couple $$ replacement), but still de-caps no problem. All my sizing/ decap was with mil crimped brass so that could be the problem or I tightened the pin too much to the die *not letting it slide up if there was an obstruction (a safety feature in the Lee die). The bullet seater is barely used.
What you see in the picture is what you get.
- Full length sizing die with de-caping pin/expander.
- Bullet seater
- Shell holder
- 1.6cc powder scoop
- Box and paper
sold
I accept gifted paypal or money order
Note: The de-caping pin is slightly bent (a couple $$ replacement), but still de-caps no problem. All my sizing/ decap was with mil crimped brass so that could be the problem or I tightened the pin too much to the die *not letting it slide up if there was an obstruction (a safety feature in the Lee die). The bullet seater is barely used.
What you see in the picture is what you get.
- Full length sizing die with de-caping pin/expander.
- Bullet seater
- Shell holder
- 1.6cc powder scoop
- Box and paper
sold
I accept gifted paypal or money order
Comment