Unconfigured Ad Widget

Collapse

Bolt locked while cleaning?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Gambino1
    Member
    • Jul 2008
    • 472

    Bolt locked while cleaning?

    Bolt was removed to wipe down and was turned and seems to be in firing position. Its a sako finnlight rifle, what needs to be done to bolt toget back in rifle?
    Thx Travis
  • #2
    Vepr62
    Senior Member
    • Oct 2006
    • 1216

    Sako

    I have a Tikka t3 lite, and I believe that Tikka and Sako actions are somewhat similar. In Tikka, it is getting cocked at opening cycle, when you turm your bolt counter clock wise with butt stock facing you. It rectracts the pin to the rear and locks it so it is not protruded from the bolt face. It is easy to de-cock it while cleaning. It has a quiet stiff spring so it is somewhat hard to cock it ouside the action. Turn your bolt up side down, bolt head facing you and bolt handle pointing to the right. You will see a rectangular piece located at a V groove. Hold your bolt body tight and with some brass or aluminum piece, or even with a piece of very durable hardwood push it away from you and to the left untill it gets out of V groove and rests on the shelf above it. It has to go all the way to the left untill it stops for you to be able to insert the bolt into receiver. Hope this helps.
    Vasiliy

    Comment

    • #3
      Gambino1
      Member
      • Jul 2008
      • 472

      Thx. I finally put enough pressure on block and got it too turn, I thoguth I would damage it, but its ok.
      Travis

      Comment

      Working...
      UA-8071174-1