Possible to fix a misaligned trigger pin hole?

[highintel]

Is it possible to fix a misaligned trigger pin hole. Pin goes through either side but gets caught on the inside wall on the opposite end. Input please.

[rman]

hammer

Sent from my Apple Galaxy Note 7

[highintel]

hammer

Sent from my Apple Galaxy Note 7

I dont think the picture shows exactly how off it is but with a digital caliper, from the base of the hole to the base below it getting 8.94mm on Side A and 9.35mm on side B

[Alex$]

hammer





(if you are being fussy about it... file)

[kcstott]

.016" off location if the pin fits through both sides use a hammer it will fit.

[rman]

ball peen

Sent from my Apple Galaxy Note 7

[bohoki]

i would run the drill bit through it again

[Reelemup]

Ball peen did the trick. Problem now is with the pin through the trigger it becomes extremely stiff. Without the pin it moves freely. Any ideas what is causing this.

bent pin ?

[Reelemup]

Is it possible to fix a misaligned trigger pin hole. Pin goes through either side but gets caught on the inside wall on the opposite end. Retap the hole and use KNS anti rotation pins? Input please. PM for better pics.

trigger pin holes are not tapped

[five.five-six]

Universal AK tool (AKA hammer)

[fourtraxmc]

I have a ream if you are close to Oakdale.

[highintel]

Ball peen did the trick.

[rman]

next up would have been jackhammer

Sent from my Apple Galaxy Note 7

[LCU1670]

I saw an ad awhile back where a guy dills out the holes to specs and taps the holes, but larger, then screws in a threaded sleeve (s), and then the pin holes are now aligned correctly.

[geedavell]

use a boring head.
a reamer will only follow the existing holes