Unconfigured Ad Widget

Collapse

EP lower problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • gsc3zny
    Senior Member
    • Jul 2011
    • 573

    EP lower problem

    OK, so I finished my blemished EP lower. Inside looks nice and smooth, FCG functions, safety functions. Takedown pins are a little tight. quite a bit tight, actually. I had to oval out the rear hole in order to get the pin to go thru the upper. Now the pin goes in all the way, but the I cant pull back the charging handle when it's assembled. When I remove the rear pin and relieve some of the pressure on the upper, the handle actuates fine. My question is, should I make the takedown pin holes a little larger so the rear pin is not so tight? How will this effect the safety and operation of this. I am using a PSA 5.56 upper
  • #2
    funnybookz
    Senior Member
    • Nov 2012
    • 1105

    I would suggest NOT making the holes bigger. You may make it so they don't fit at all. My forged lower doesn't fit tight, so I use the Accuwedge. I'd prefer the tighter fit.

    You may have another problem other than the takedown pin. Not sure.
    Illustrator and Graphic Designer

    Comment

    • #3
      kcstott
      I need a LIFE!!
      • Nov 2011
      • 11796

      Well what you should have done was verify what was out of spec then correct that. Now you have an egged hole in a lower. and polymer lower at that.
      not good dude.

      Comment

      • #4
        Bobby Hated
        Senior Member
        • Oct 2010
        • 1616

        take a fine tooth hand file with a circular shaped blade and LIGHTLY remove a tiny tiny bit of material from the 6 O-Clock side of the hole until the problem goes away.

        it sounds out of spec though so you could call EP and ask to exchange it. the takedown pin holes should only need a very light filing to remove excess material around the edges from the molding process.
        USPSA Master TY-71084

        Comment

        Working...
        UA-8071174-1