I've got a manual Taig mill to work on 80% lowers and was curious to know if someone could link me to a good ball roughing end mill bit so I can clear material faster. A link to a site that would be what you folks would recommend. The largest shank my Taig will hold is a 3/8".
Unconfigured Ad Widget
Collapse
|
|
|
|
|
|
|
|
End Mill Bit - Help
Collapse
X
-
Ball end mill will not help you clear material faster. It will actually slow you down.
As the surface area of the end mill contact contact surface goes up so does your wattage load on your spindle. A ball end mill buried to full ball depth has about 4X the surface area of a flat bottom end mill.
Get a 3 flute 3/8" mill set you RPM at about 1800 and take .250" depth of cut at about 10" a minuteComment
Calguns.net Statistics
Collapse
Topics: 1,870,805
Posts: 25,176,197
Members: 358,862
Active Members: 5,396
Welcome to our newest member, 1776 Arms.
What's Going On
Collapse
There are currently 25893 users online. 124 members and 25769 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.

Comment