Saiga conversion

[Tacit Blue]

I have a Saiga conversion, i'd like to replace the front end with a 74 FSB. My rifle uses pins, so that means no drilling?

I heard you can do this two ways

1) use a dremel and cut the fsb off and use a plastic dead blow hammer

2) 6-12 ton press,which slides it off like butter.


Im located in SD, if someone could help a brother out that be great

[hellayella]

contact jruta or kcstott

[NorCalXJ]

Punch out pins and use press to slide off.

[atsaubrey]

Contact KCScott for sure, he'll hook you up. Damn good guy

[The Paper Pimp]

damn good guy that might be in violation of federal law

[Gio]

damn good guy that might be in violation of federal law

Care to elaborate?

[The Paper Pimp]

there are 2 threads just below on the subject.


(I'm on my phone and it's a PITA to copy/paste links)

[hawaii five-0]

Leave the law enforcement to L.E.O's. They certainly visit this forum enough. Sick of members trying to earn their junior law enforcement badge by speculating in an open forum about possible ways something could be illegal. If you truly had KC's best interest in mind, and thought he was doing something wrong, a PM might be in order.

[zfields]

damn good guy that might be in violation of federal law

Seriously, just stop.

sent from my damn tappy device...

[MUKAK]

damn good guy that might be in violation of federal law

not this guy again lol

get MRPLINK in here, he will check him