I have a brand new 700CDL in 300WM and at the range today it doesn't want to extract fired brass. I'm able to get it out but barely. I'm shooting factory
Federal standard (blue box) 180gr soft point ammo. I also shot a few rounds of Federal Premium accubond 180gr with nickel cases that extracted almost like it should but still had to use more than average presser to get it out. I have two other 700s and it's obvious something is amiss. The brass cases after being fired, mic'ed out to be within spec according to my manual. The bolt is alittle firm when going into battery with a new round in the chamber, but not unreasonable hard. Any ideas???
Federal standard (blue box) 180gr soft point ammo. I also shot a few rounds of Federal Premium accubond 180gr with nickel cases that extracted almost like it should but still had to use more than average presser to get it out. I have two other 700s and it's obvious something is amiss. The brass cases after being fired, mic'ed out to be within spec according to my manual. The bolt is alittle firm when going into battery with a new round in the chamber, but not unreasonable hard. Any ideas???

Comment