Unconfigured Ad Widget

Collapse

Deburring a Lower

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mhswlee
    Member
    • Apr 2012
    • 241

    Deburring a Lower

    Hi, so I recently completed an 80% lower, and I have been meaning to debur the thing. To this end, I have purchased a deburring tool. Now, I have read many accounts online, and I have realized that there seems to be a lot of variability in how people like to debur their lowers. So, I have some questions:

    1) What parts of the lower NEED to be deburred? (I would prefer to have less opportunities to screw up. )
    2) Do these parts all need to be chamfered as well? If so, how extreme of a bevel?
    3) If I were to just beadblast the thing, would I need to bother with the deburring and chamfering?
  • #2
    tuolumnejim
    I need a LIFE!!
    • Jun 2008
    • 11218

    You need to deburr any sharp edge.

    As for how much do it minimally but there should also be a specification in the prints.
    In a state where corruption abounds, laws must be very numerous.
    Publius Cornelius Scipio

    Tyranny is defined as that which is legal for the government but illegal for the citizenry.
    ― Thomas Jefferson

    Our Constitution was made only for a moral and religious people. It is wholly inadequate to the government of any other.
    John Adams

    Comment

    • #3
      12voltguy
      Veteran Member
      • Feb 2006
      • 4003

      ceramic beads in a virbrator for brass shells might do the trick

      Comment

      • #4
        mhswlee
        Member
        • Apr 2012
        • 241

        So I used my tool to remove the sharp burrs on the holes that I drilled. I then used some 2000 grit sandpaper to smooth out all of the cut edges.

        I have no chamfering except a very slight one on the safety selector hole, as I was unsure if it would be beneficial for the smaller holes, which have pins that do not rotate in and of themselves.

        I will let the beadblasting and anodizing take care of the rest.

        Thanks for the responses.

        Comment

        • #5
          ar15barrels
          I need a LIFE!!
          • Jan 2006
          • 57202

          deburr any sharp edges that you might come into contact with.
          Any edges that are hidden by assembled parts really won't matter, but it's still the right-thing-to-do to also deburr those edges.
          How much you deburr is all up to you.
          Randall Rausch

          AR work: www.ar15barrels.com
          Handguns: www.handgunbarrels.com
          Bolt actions: www.700barrels.com
          Foreign Semi Autos: www.akbarrels.com
          Most work done while you wait on a scheduled shop visit.

          Comment

          Working...
          UA-8071174-1