I have an G22 i picked up from a Calgunner and it did great for the first two or three trips out. Had a major problem with the trigger bar, extractor and the actuation arm/pin. Walther sent replacement free of charge. After the installation of new part everything functions great until i put the stock back in place. The trigger will not actuate with the stock in place. I have done several intenet searches, and found that this is not an uncommon problem, and while I have found many ingenious ways to "fix" the problem, including rolled card board. I dont find any real sollutions, such as an aftermarket trigger bar.
Anyone have any experience with this issue?
Thanks in advance.
SM
Anyone have any experience with this issue?
Thanks in advance.
SM

Comment