Prince 50 mag release help

[meSSican]

I installed one of these on an AR and have a question about it. http://www.midwayusa.com/product/937...08-with-wrench

I am assuming that the red tool is not to stay installed on the rifle correct? The only way I can get it installed is with the red tool but it is threaded so I cannot remove the tool without backing the set screw all the way down. Am I needing a special tool to get it screwed down without the red button or is there another way? Thanks for your help.

[CSACANNONEER]

Go straight to the manufacturer!

http://bulletbutton.com/downloads/

[Tripper]

The tip of the tool is not threaded
Only screw it down to that point
Just back it off till you can pull out the tool, the button screw will still be where it should be

[Diskea]

He got it right

The tip of the tool is not threaded
Only screw it down to that point
Just back it off till you can pull out the tool, the button screw will still be where it should be

The tip goes far enlightened to hold the nut in place. Hold onto that tool though you will need it for end of days lol. But honestly if you decide to get a .22lr conversion you can thread that baby on and have a QD mag release.

[Ninety]

The tip goes far enlightened to hold the nut in place. Hold onto that tool though you will need it for end of days lol. But honestly if you decide to get a .22lr conversion you can thread that baby on and have a QD mag release.

That is debatable .. and could lead to criminal charges of possession of an assault weapon.