CNC Warrior Receiver Question

[Seaweed02]

A few months ago I bought an unissued, matching number Bulgarian milled parts kit. Then I bought a CNC Warrior Russian pattern fixed stock receiver for it. I had it built by Turbothis, and it was just delivered to my local FFL, and I went down to get the paperwork done and take a look at it.

Well the forward part of it, on the bottom where the lower hand guard should fit in is open. Can someone tell me how the lower handguard is held in place on those receivers? Or do I need to have a piece of metal welded over that open space. Here is the link to CNC http://www.cncwarrior.com/shop/22614...tock-receiver/ on one of the three pics it shows the open spot where you can see the hole for the bullet guide rivet. Well that is also where the lower handguard should go in. Any advice?

[Gowking]

There is a tomb stone shaped cover that slides in and is peened in place. Your kit should have had one or two depending on if it was a fixed stock or underfolder kit.

-MRA

Edited to add:

Here you go: http://www.cncwarrior.com/shop/23110...e-cover-plate/

[Seaweed02]

Wasn't with the kit

It wasn't with the kit. But I have since discovered that I had to buy it from CNC Warrior, and it only cost 5 bucks. I just called them a little while after posting this thread and ordered one. Thanks man.

[AKSOG]

Nevermind