Romanian PSL receiver issues

[sdlocalkid85]

I have a romanian PSL kit I bought some years back and i was lucky enough to get it before the barrel law took effect, so it is attached and headspaced properly to the front trunion. I'm having difficulty building the receiver from a bent blank. I don't really have any CAD or blue prints for the holes. I want to know if anyone who has built one could possibly tell me where to get the blue prints or any sort of information that could lead me to the completion of the rifle. As it stands right now, I have three unfinished kits I am trying to complete, the Yugo underfolder, RPK, and PSL are all sitting in boxes. I noticed that this forum has a lot of experienced builders and I greatly appreciate anyone's input that could help me finish my kits. thanks

[yari]

Check cold steel solutions, I thought they had a stick on template for them.

[Holescreek]

These help? 've had these up on weaponsguild for a few years now and have to give the disclaimer that this is what I used on my first build and it worked for me. I've found that not all trunnions are the same so measure yours before cutting metal. Before I started on mine I found several different prints floating around on the net and none of them matched, especially around the front trunnion holes.

[nick]

Check cold steel solutions, I thought they had a stick on template for them.

They don't, they just sent a blueprint to go with the blanks.