mac 10/11

[bmacpolo]

Has anyone in the socal area done any Mac 10/11 builds. If you have the tools and the time to help someone I would be glad to pay.

thanks

[bmacpolo]

No San Diego help?

[fxjets]

Im just gearing up on a M10/45. Have all the parts, mentally gearing up to build a press. I figure Ill copy the AK Builder press pieces. Your more than welcome to join in.

[arsilva32]

i just got my frame and parts tac welded together.thats the most i could do as im a very green welder. i was going to have a guy tig weld it for me then i can do the grinding and shaping and assembling.

[scotthmt]

There isn't much to it, if you have a welder a dremel, some grinding bits and a basic knowledge of firearm operation it's cake. For some reason mine only liked cycling steel cased ammo though. Brass wouldn't eject fast enough

[chiz]

I hate to tell you but those side plates are for an open bolt MAC. There are not enough holes for a closed bolt semi and the holes that are there are in the wrong place. Not to mention you are missing the entire back piece and rear sight plate.

[arsilva32]

I hate to tell you but those side plates are for an open bolt MAC. There are not enough holes for a closed bolt semi and the holes that are there are in the wrong place. Not to mention you are missing the entire back piece and rear sight plate.

lol no kidding really?

yes i know there the only side plates i could find, the holes will be plug welded and re-drilled for the MPA closed bolt semi internals i have

ps there are 4 holes in the semi CB set up ,however they are in different locations,yes and i have not welded the back plate or the front shims due to the fact..... well you can see my very poor welding skills. this however will not stop me from a CA legal completed build.

[bmacpolo]

Awesome thanks guys I will get in touch with you

[rromeo]

Where do you get the parts? I may give this a run after my AK build.

[bmacpolo]

I got my parts from gunbroker