making a 20rd mag into 10rd

[greggywhat]

What are the best ways to do this thanks

[aplinker]

What are the best ways to do this thanks

Scissors.

I think you mean magazine. Personally I wouldn't do it. IMHO you're far more protected buying either 10/20's or just using a standard 10rd mag. That being said, I would rivet to the 10rd level for the follower and use LOTS of epoxy and fill the bottom.

Permanence is an issue.

What kind of firearm is this for?

[greggywhat]

l1a1

[Flux Capacitor]

Clip isn't a magazine

[rorschach]

Get ahold of rssslvr, he and jpglee can mod your magazine to 10 rounds, I have bought their FAL and AK mags, and they are THE BEST.

[thedrickel]

FEDUP has been doing FAL mag 10/20's too, but metrics only, if you supply an inch mag I'm sure he'll do it for you.

[bohoki]

best way is to take off the floorplate
pull the spring off the follower
holding magazine upside down
place 10 rounds in under the follower
insert a tape measure finding the length of the bottom of the follower to the bottom of magazine(non lip side)
transfer mark outside of magazine and cut it a little longer then figure out a way to mount the floorplate back either bending out or bending in the sides depending on the design

[greggywhat]

I cut the mag in half and put a trap door on the bottom thanks for the help.

[FEDUPWBS]

I cut the mag in half and put a trap door on the bottom thanks for the help.

Post pics