Sig P320 Trigger modification for LESS creep.

[newbie1234]

I just acquire Sig P320 X5 Legion, I will use this gun for the range punching paper no HD intent, after 500+ rounds break in I observed:
- Trigger takeup distance is OK.
- Trigger creep distance is NOT OK. For my style of shooting, the trigger creep is TOO LONG before the break.
- The trigger pull weight to break is OK (3.5# at the lowest point of trigger. 4.5# at the middle of trigger)
- Trigger reset distance is OK.
Do you Aces know any company sell the "trigger modification kits" that will reduce the trigger creep to minimal.
Thanks You.

[oddjob]

Gray Guns (Oregon) does good work and sells trigger kits. The Sig Armorer from Texas does too.

[newbie1234]

Thanks Oddjob for recommending Gray Guns and The Sig Armorer. I picked the GG because of the price about half of TSA.
Notes after the installations of GG :
- The GG trigger kits came with two set of springs: competition and moderate. I chose the competition kits.
- The trigger pull is: 2.5# at the middle of trigger, 2# at the tip end of the trigger.
- The creep before the break is minimal, I am very happy with the creep.
- P320 CA version has the manual safety so a little bit difficult than MOST of the P320 (which have no manual safety).
- Installing the trigger bar is quite difference than what you saw on you tube (most of them no manual safety), I had to:
. make the "new GG trigger" connect to the "trigger-bar" first,
. connect the "trigger-bar" to the "FCU" (no "trigger bar spring" attached)
. connect "trigger bar spring" to the "trigger-bar".
. used the "special V screwdriver tool" to pry/mount/... the "trigger bar spring HOOK" to the FCU. (Or the spring is the last part to install).
IMG_2525.jpg

[Mp5marley]

installing a skelton trigger on california m18 was so freaking hard! not like the videos! there's litreally 1/4" less room to work that spring onto trigger bar